Finally got the nomadic_device to stand up...and then some. Half-laps on the end of the legs with corresponding voids on the top pieces lock three units into one. The cable tensioning system makes sure they dont come apart...even when you want them to.
The model folds as advertised, and hinges well on the dowel-rod pin.
The base is securely attached to the table through the threaded-rod/wing-nut combination.
The track system works well to both keep the nomadic_device upright and well-grounded.
The Bad:
There is just not enough lateral strength to keep the nomadic_device standing when a load is applied.
The tensioning system tensions well, but getting the nomadic_device in and out of tension is sketchy. It feels like it could break some piece at any moment.
There are several bad edges and chipped pieces of wood.
There are some dimensions that arent quite right. For example, where the modular rests on the track. The top stringer should keep the ribs together in a way that compresses the modular so that it can contribute to the strength of the sections of frame. This didnt happen, the space is a bit too large.
Overall the project was a valuable experience in not only working in a group, but handling real materials, finishing real materials, etc. Complications certainly did arise due to the limited access to the shop, and...conflicting schedules amongst group members.
No comments:
Post a Comment